Wolf · Los Angeles
Cooktop Repair
Wolf gas cooktops, rangetops and induction tops: sealed burners, spark modules, coils, touch controls and the wiring under the glass.
What people call about
- Induction zone drops out a few minutes into cooking
- Flame lifts off the burner cap and blows itself out
- One element runs flat out wherever the knob sits
- Cooktop trips the breaker when two zones run together
How the fault gets found
Gas, induction and sealed-burner rangetops fail for completely different reasons, and the difference matters before anyone opens anything. A dropping induction zone is usually heat or a sensor; a lifting gas flame is usually the cap, the port or the regulator.
- Induction: ventilation under the cabinet, coil sensors and the inverter board
- Gas: cap seating, port blockage, orifice size and the spark module channel
- Switch bank behind the fascia — grease running into it makes two burners light as one
- Current draw per zone, load-tested together rather than one at a time
What it costs
Quoted as a range, agreed before the work
What these repairs come to on Wolf cooking equipment in Los Angeles — parts and labour, finished and demonstrated working.
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
- Igniter or spark module
- $170–$470
- Burner valve or orifice service
- $270–$630
- Oven thermostat or sensor calibration
- $190–$470
- Convection fan or motor
- $260–$690
- Control board or touch panel
- $450–$930
- Door hinge, glass or seal
- $280–$740
Two kitchens with the same symptom rarely need the same part, which is why each line is a range: the low end is a switch, a sensor or an igniter, the high end a board or a full burner assembly with the labour to reach it. The figure for your appliance is worked out on site and agreed with you before anything is opened, and the $89 service call comes off it once you approve the repair.
Most of these decisions come down to the alternative: $8,340–$18,770 for a comparable professional range, before installation and ventilation work.
Reviews
What owners said after a cooktop repair
Same appliance, same fault, different kitchens across Los Angeles.
5.0/ 5625 reviews
Grease from years of frying had run down into the ignition switches, so two burners lit whenever you turned one. He stripped the fascia, replaced the switches and cleaned the loom. Straight answer, no theatre.
Thibault M.
Two zones shut themselves off whenever the big paella pan went on. The cabinet fitter had boxed in the vent slot underneath, so the electronics never got any air. He cut a proper opening and it holds full power.
Roxana E.
Left front zone would run for a few minutes then drop to nothing. Not the pan, as two other people had told me, but a failed coil sensor. He proved it with a clamp meter before ordering anything.
Gemma T.
Two ways in, and nothing to fill out
Tell us what it is doing and we will tell you what it is
Have the model number to hand if you can — on a Wolf range it is on the plate behind the kick panel or inside the oven door frame. It decides which parts travel with the technician.
$89 service call, flat, credited against an approved repair · line answered 24/7