Wolf · Los Angeles
Range Repair
Wolf dual-fuel and all-gas ranges: ignition, burner tuning, oven cavity heat and the boards behind them, diagnosed in one visit.
What people call about
- Burner sparks over and over but the flame never catches
- Oven went dead after a summer outage while the cooktop still works
- The low setting has no low — a sauce either sits cold or scorches
- Oven lights with a thump you can hear in the next room
How the fault gets found
A range is two appliances sharing a fascia, and the fault almost always sits on one side of that line. Burners that spark but never catch, a simmer with no low end and an oven that died in a power cut are three unrelated repairs, so the visit starts by deciding which half is actually broken.
- Spark at the electrode, and whether it is arcing to the cap instead of the gas
- Burner ports and the bypass screw setting — the usual cause of a lost simmer
- Oven safety valve, igniter draw and the sensor reading against a probe on the rack
- Relay board and the outlet behind the range, after any outage or surge
What it costs
Quoted as a range, agreed before the work
What these repairs come to on Wolf cooking equipment in Los Angeles — parts and labour, finished and demonstrated working.
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
- Igniter or spark module
- $170–$470
- Burner valve or orifice service
- $270–$630
- Oven thermostat or sensor calibration
- $190–$470
- Convection fan or motor
- $260–$690
- Control board or touch panel
- $450–$930
- Door hinge, glass or seal
- $280–$740
Two kitchens with the same symptom rarely need the same part, which is why each line is a range: the low end is a switch, a sensor or an igniter, the high end a board or a full burner assembly with the labour to reach it. The figure for your appliance is worked out on site and agreed with you before anything is opened, and the $89 service call comes off it once you approve the repair.
Most of these decisions come down to the alternative: $8,340–$18,770 for a comparable professional range, before installation and ventilation work.
Reviews
What owners said after a range repair
Same appliance, same fault, different kitchens across Los Angeles.
5.0/ 51,679 reviews
After a Sunday outage the range came back with a blank panel and no oven at all. He replaced a surge-damaged relay board, then checked the outlet before leaving. The burners had never quit, and now everything works.
Rodolfo H.
Simmer was hopeless: either a roar or nothing. Turned out the bypass screws had never been set for this gas after the remodel. He tuned all six burners and a sauce finally sits quietly.
Sylvana R.
The oven lit with a thump loud enough to rattle the door in our old kitchen. Delayed ignition from a partly blocked burner tube, not the control board someone else had blamed. Cleaned and adjusted, and it lights softly.
Rosalva C.
Two ways in, and nothing to fill out
Tell us what it is doing and we will tell you what it is
Have the model number to hand if you can — on a Wolf range it is on the plate behind the kick panel or inside the oven door frame. It decides which parts travel with the technician.
$89 service call, flat, credited against an approved repair · line answered 24/7